Texas Instruments TI-82 STATS

12–12 Statistics
82D315~1.DOC TI-83 international English Bob Fedorisko Revised: 10/26/05 1:36 PM Printed: 10/27/05 2:53
PM Page 12 of 38
To create a name in the stat list editor, follow these steps.
1. Follow step 1 on page 12.11 to display the
Name= prompt.
2. Press [letter from A to Z or q ] to enter the first letter of the
name. The first character cannot be a number.
3. Enter zero to four letters, q, or numbers to complete the new
user-created list name. List names can be one to five
characters long.
4. Press Í or † to store the list name in the current
column of the stat list editor. The list name becomes an item
on the
LIST NAMES menu (Chapter 11).
To remove a list from the stat list editor, move the cursor onto the
list name and then press {. The list is not deleted from memory;
it is only removed from the stat list editor.
Note: To delete a list name from memory, use the MEMORY
DELETE:List
selection screen (Chapter 18).
You can remove all user-created lists from the stat list editor and
restore list names
L1 through L6 to columns 1 through 6 in either
of two ways.
• Use SetUpEditor with no arguments (page 12.21).
• Reset all memory (Chapter 18).
You can clear all elements from a list in any of five ways.
• Use
ClrList to clear specified lists (page 12.20).
• In the stat list editor, press } to move the cursor onto a list
name, and then press ‘ Í.
• In the stat list editor, move the cursor onto each element, and
then press { one by one.
• On the home screen or in the program editor, enter
0!
!!
!dim(listname) to set the dimension of listname to 0
(Chapter 11).
• Use
ClrAllLists to clear all lists in memory (Chapter 18).
Using the Stat List Editor (continued)
Creating a Name
in the Stat List
Editor
Removing a List
from the Stat List
Editor
Removing All
Lists and
Restoring L
1
through L6
Clearing All
Elements from a
List