1-12 Operating the TI-82 STATS
82STAT~3.DOC TI-83 international English Bob Fedorisko Revised: 10/28/05 12:11 PM Printed: 10/28/05 12:11
PM Page 12 of 24
Sequential graphing-order mode evaluates and plots one
function completely before the next function is evaluated and
plotted.
Simul (simultaneous) graphing-order mode evaluates and plots
all selected functions for a single value of
X and then evaluates
and plots them for the next value of
X.
Note: Regardless of which graphing mode is selected, the
TI-82 STATS will sequentially graph all stat plots before it graphs any
functions.
Real mode does not display complex results unless complex
numbers are entered as input.
Two complex modes display complex results.
• a+bi (rectangular complex mode) displays complex numbers
in the form a+bi.
•
re^qi (polar complex mode) displays complex numbers in
the form re^qi.
Full screen mode uses the entire screen to display a graph or edit
screen.
Each split-screen mode displays two screens simultaneously.
• Horiz (horizontal) mode displays the current graph on the top
half of the screen; it displays the home screen or an editor on
the bottom half (Chapter 9).
•
G.T (graph-table) mode displays the current graph on the left
half of the screen; it displays the table screen on the right
half (Chapter 9).
Setting Modes (continued)
Sequential, Simul
Real, a+bi, re^qi
Full, Horiz, G.T
To Next Page
Loading...
Need help?
General
