Texas Instruments TI-82 STATS

B–6 General Information
826FEC~1.DOC TI-83 Intl English, Appendix B Bob Fedorisko Revised: 10/27/05 3:16 PM Printed: 10/27/05
3:16 PM Page 6 of 12
Error Type Possible Causes and Suggested Remedies
DOMAIN
¦ You s
p
ecified an ar
g
ument to a function or instruction
outside the valid ran
g
e. This error is not returned durin
g
g
ra
p
hin
g
. The TI-82 STATS allows for undefined values on a
graph. See Appendix A and the appropriate chapter.
¦ You attem
p
ted a lo
g
arithmic or
p
ower re
g
ression with a LX o
r
an exponential or power regression with a LY.
¦ You attempted to compute GPrn( or GInt( with pmt2 < pmt1.
Duplicate Name
A variable
y
ou attem
p
ted to transmit cannot be transmitted
b
ecause a variable with that name alread
y
exists in the receivin
g
unit.
Error in Xmit
¦ The TI-82 STATS was unable to transmit an item. Check to
see that the cable is firml
y
connected to both units and that
the receiving unit is in receive mode.
¦ You pressed É to break during transmission.
¦ You attem
p
ted to
p
erform a backu
p
from a TI.82 to a
TI-82 STATS.
¦ You attem
p
ted to transfer data
(
other than L1 throu
g
h L6
)
from a TI-82 STATS to a TI.82.
¦ You attem
p
ted to transfer L1 throu
g
h L6 from a TI-82 STATS
to a TI.82 without usin
g
5:Lists to TI82 on the LINK SEND
menu.
ILLEGAL NEST
You attem
p
ted to use an invalid function in an ar
g
ument to a
function, such as seq( within expression for seq(.
INCREMENT
¦ The increment in seq( is 0 or has the wron
g
si
g
n. This error
is not returned durin
g
g
ra
p
hin
g
. The TI-82 STATS allows for
undefined values on a graph.
¦ The increment in a For( loop is 0.
INVALID
¦ You attem
p
ted to reference a variable or use a function where
it is not valid. For exam
p
le, Yn cannot reference Y, Xmin, @X,
or TblStart.
¦ You attem
p
ted to reference a variable or function that was
transferred from the TI.82 and is not valid for the
TI-82 STATS. For exam
p
le,
y
ou ma
y
have transferred UnN1
to the TI-82 STATS from the TI.82 and then tried to
reference it.
¦ In Seq mode,
y
ou attem
p
ted to
g
ra
p
h a
p
hase
p
lot without
defining both equations of the phase plot.
Error Conditions (continued)