505 Programmable Hardware Manual (PHM)
© Tibbo Technology Inc.
* The actual measurement range is limited by the operating temperature range of
the Cable Probe itself, which is -40 to +125°C.
All specifications are subject to change without notice and are for reference only.
Tibbo assumes no responsibility for any errors in this Manual, and does not make
any commitment to update the information contained herein.
Think the above table should contain additional data? Do not just assume that you
know the answer — talk to Tibbo! Remember that the ultimate responsibility for all
decisions you make regarding the use and the mode of use of Tibbo products lies
with you, our Customer.
Companion Products
The following companion products are currently being offered by Tibbo:
·
WA2000 (802.11a/b/g/n Wi-Fi + BLE 4.2 add-on module)
·
GA1000 (802.11b/g Wi-Fi add-on module)
·
RJ203 (jack/magnetics module)
WA2000
Introduction
The WA2000 is an upgrade to Tibbo's GA1000 Wi-Fi add-on module. Notable
improvements include:
·
Support for the 5GHz Wi-Fi band (802.11a and 801.11n standards).
·
Support for BLE4.2 communications.
·
WPA key calculation completely on the module, complex calculations in Tibbo
BASIC/C are no longer necessary.
·
Firmware stored in the module's flash memory, thus eliminating the need to send
the firmware file into the module on every boot.
·
The firmware can be upgraded from a Tibbo BASIC/C app or over-the-air (OTA),
from Tibbo Updater iOS and Android apps.
·
Wide operating temperature range: -40 ~ +85C.
To Next Page
Loading...
Need help?
General