Tiesse Imola LX 5200 User Manual

Quality of service
USER GUIDE
281
set autocmd tc qdisc add dev eth0 root tbf rate 1000kbit latency 50ms burst 20000
COMANDI SET DSCP E SET DSCP-CLASS
The command set dscp allows to classify a stream of packets and to set the DSCP (Differentiated
Service Code Point) value with the packet that will be sent.
Use the command as below:
set dscp VALUE protocol PROT from ADDRESS to ADDRESS out-interface INTF in-interface INTF
set dscp VALUE protocol PROT from ADDRESS source-port PORT to ADDRESS dest-port PORT out-interface INTF in-interface INTF
where:
 VAL is a numeric value from 1 to 65 that you must insert in the packet's DSCP field
 PROTOCOL tells the protocol used, that can be:
 TCP
 UDP
 ICMP
 GRE
 OSPF
 L2TPV3
 any
 ADDRESS is a network prefix (10.10.10.0/24) or the keyword any, used to indicate any
address
 PORT is a numeric value that identify the UDP or TCP port, or a string that identify the
service (Telnet, SSH, SNMP,...)
The command set dscp-class has the same syntax, but it allows to directly specify the DSCP
class:
set dscp-class CLASS-VALUE <options>
where the CLASS-VALUE can be: cs0, cs1 ... cs7, be, af11,af12, af13, af21, af22, af23, af31,
af32, af33, af41, af42, af43, ef.

Tiesse Imola LX 5200 Specifications

General

Brand	Tiesse
Model	Imola LX 5200
Category	Network Router
Language	English