Tiesse Imola LX 5200 User Manual

ADSL interface
USER GUIDE
61
ADSL INTERFACE
CONFIGURATION
Imola XX10 models only support ADSL connections, while XX20 models support both ADSL and
ADSL2+ connections.
In ADSL connections the maximum bandwidth is:
 downstream speed up to 8 Mbps
 upstream speed up to 1 Mbps
In ADSL2+ connection the maximum bandwidth is:
 downstream speed up to 24 Mbps
 upstream speed up to 3.5 Mbps
A maximum of 8 PVCs (Permanent Virtual Circuit) is supported.
Conformity to the following standards:
 ADSL: G.992.1 (G.dmt) - Annex A (ADSL over POTS), G992.2 (G.lite), ANSI T1.413 issue 2
 ATM: ITU T-I.361, ITU T.I.363.5, ITU T-I.432, ITU T.I.610, ITU T-I.731
 RFC 2684 (former RFC 1483 Multiprotocol over ATM)
 RFC 2364 (PPP over ATM)
 RFC 2516 (PPP over Ethernet)
In Imola XX20 models the following standards are also supported:
 G.992.3 annexA, B, I, J, L (extended reach), M (double upstream)
 G.992.4 – g.Lite.bis
 G.992.5 annexA, B, C, I, J, M
It is possible to configure and activate the ADSL link by using CLI commands.
The command
set adsl on
activates the ADSL interface.
The command
set adsl off
deactivates the ADSL interface
The command
set no-adsl
deactivates the ADSL interface and disables the configuration.
Before the activation, the ADSL interface must be configured according to the contractual values
provided by the Service Provider.
In order to define the encapsulation type the command is:

Tiesse Imola LX 5200 Specifications

General

Brand	Tiesse
Model	Imola LX 5200
Category	Network Router
Language	English