Tiesse Imola LX 5200 User Manual

SHDSL interface
USER GUIDE
73
SHDSL INTERFACE
CONFIGURATION
The SHDSL interface is available through 2 connectors RJ11 labelled Line0 and Line1. Each of them
provides a 2 Mbps bandwidth and may be used simultaneously (4-Wire) in order to support the
following bandwidth:
 Downstream speed up to 4 Mbps
 Upstream speed up to 4 Mbps
A maximum of 4 PVCs (Permanent Virtual Circuit) are supported.
Conformity to the following standards:
 ETSI TS 101 524 (SDSL ETSI)
 ITU-T G.991.2, Annex A, B, F, G (G.SHDSL) included
 ITU-T G.994.1 (G.hs)
 IEEE 802.3ah-2004 (IEEE EFM)
 ANSI T1E1.4/2003-334R6 (ATM bonding)
 ITU G.998.1 (ATM bonding)
 ITU G.998.2 (EFM bonding)
In order to activate the SHDSL interface the command is:
set shdsl on
In order to deactivate the SHDSL interface the command is:
set shdsl off
In order to deactivate the SHDSL interface and disable the configuration the command is:
set no-shdsl
Before the activation, the SHDSL interface must be configured according to the contractual values
provided by the Service Provider.
In order to configure the chip SHDSL in ATM or EFM mode the command is:
set shdsl chipmode atm|efm
In order to configure the Annex type the command is:
set shdsl annex A|B|B-ANFP
In order to configure the 2-Wire mode, the command is:
set shdsl line-mode 2-Wire
This command activates the 2-Wire mode on Line0.
In order to configure the 4-Wire mode, the command is:
set shdsl line-mode 4-wire standard
In order to configure the SHDSL chip as CPE or CO, the command is:

Tiesse Imola LX 5200 Specifications

General

Brand	Tiesse
Model	Imola LX 5200
Category	Network Router
Language	English