set gprs direct-ip
so that the network interface name that match the main APN would be wwan0, while wwan1 will be
for the second one.
DISPLAYING GPRS CONFIGURATION, STATUS AND STATISTICS
It is possible to display information about configuration, statistics and status of the GPRS interface.
The CLI command is:
show interface gprs config|statistics|status
For example, the command show interface gprs config produces the following output:
show interface gprs config status
root@Imola> show interface gprs config
Start GPRS: yes
APN: ibox.tim.it
PPP Login: mylogin
PPP Passwd: mypasswd
MTU: 576
Idle Timeout: 3600
Masquerade: yes
Deflt-Route: yes
The command show interface gprs status shows the status of the session. The video output
produced may change according to the access technology:
root@Imola> show interface gprs status
Signal Quality: +CSQ: 17,99
Network: HSDPA/UMTS
IMSI: 222017302670415 IMEI: 355841030174450
There is an active GPRS Connection:
31: ppp0: <POINTOPOINT,MULTICAST,NOARP,UP> mtu 1500 qdisc pfifo_fast qlen 3
link/ppp
RX: bytes packets errors dropped overrun mcast
40 4 0 0 0 0
TX: bytes packets errors dropped carrier collsns
77 6 0 0 0 0
inet 217.201.91.46 peer 192.168.254.254/32 scope global ppp0
root@Imola> show interface gprs status
Signal Power: CSQ = 23 => -67 dBm
Network: HSDPA/UMTS vodafone IT
HSDPA Category: 24 HSUPA Category: 6
Current Time: 75749 Temperature: 38
Bootup Time: 1 Mode: ONLINE
To Next Page
Loading...
Need help?
General
