sshkey save
saves the keys on a non-volatile memory so that they can be available at the router reboot.
PASSWORD RECOVERY PROCEDURE
If you are using a serial connection, it is possible to use a special login which allows to access
without asking a password, in order to recover the factory configuration.
The login value can be the default one or you can concur a specific value with your costumer, that
wil be used only for him.
On certain models of router, if you use a serial connection, you can apply as follow:
At the router prompt, press simultaneously the key “Shift” (uppercase button) and the key
“z”
When the prompt is up, type the commands:
setenv config factory
saveenv
boot
With those commands the router reset itself to the factory configuration and the previous settings
are lost.
REBOOT OF THE ROUTER
The router can be rebooted using the command:
reboot
After the reboot, all the unsaved changes (through the command save), will be lost.
A time programmed reboot can be configured, specifying after how many seconds this must be
done. The command is:
schedule-reboot wait N
The command prompt is returned to the user, so that other commands can be executed or to end
the current session.
The programmed reboot can be disabled with the command:
no-schedule-reboot
It is advisable not to make configuration saves when a time programmed reboot has been set.
DEFAULT SETTINGS
Imola default configuration includes:
eth0 address (service): 10.10.113.1/16
eth1 address (and integrated switch): 172.151.113.1/16
SNMP v1 and v2 enabled, with public community for read-only accesses and Tiesseadm for
read-write accesses.
To Next Page
Loading...
Need help?
General
