Tiesse Imola LX 5200 User Manual

VDSL interface
USER GUIDE
68
vdsl2-prof-8a
vdsl2-prof-8b
vdsl2-prof-8c
vdsl2-prof-8d
The command must be repeated for each modality that you want to enable. To return to the default
configuration the command is:
set dsl advanced no-line-types
N.B.: the command advanced is not visible neither as option nor in the auto-complete mode.
To activate the connection:
set dsl on
To knock down the connection:
set dsl off
To delete the configuration:
set no-dsl
ADSL CONFIGURATION
The same commands used for Imola XX20 are available for the ADSL configuration on those models
that have ADSL interface only.
The ADSL mode supports up to 8 PVC (Permanent Virtual Circuit), and to configure them it can be
used:
set ADSL pvc_number <value>
To configure the encapsulation type:
set ADSL encap rfc1483-llc|rfc1483-bridged|ppoa-vcmux|PPPoe-llc
To configure vpi and vci:
set ADSL pvc atm0|…|atm7 vpi <value> vci <value>
To configure pvc encapsulation:
set ADSL pvc atm0|…|atm7 encap rfc1483-llc|rfc1483-bridged|ppoa-vcmux|PPPoe-llc
To configure the IP address:
set ADSL pvc atm0|…|atm7 ipaddr <value>
To remove the IP address:
set ADSL pvc atm0|…|atm7 no- ipaddr
To configure netmask:
set ADSL pvc atm0|…|atm7 netmask <value>
To restore the default netmask:
set ADSL pvc atm0|…|atm7 no-netmask
To configure the mtu:

Tiesse Imola LX 5200 Specifications

General

Brand	Tiesse
Model	Imola LX 5200
Category	Network Router
Language	English