In order to display local system date, the following command is used:
show date
It is good practice activating the NTP service when the remote connection becomes active. For
example, in case of ADSL connection, the following trigger should be programmed:
set trigger adsl up set ntp on
It is possible to configure the service in order that it gives the date to possible clients requiring it.
The command is:
set ntp listen on <ip-address>
NTP TRIGGERS
It is possible to schedule triggers to be execute when the router synchronizes the date with the NTP
server. For example:
set trigger ntp up logger Router has been synchronized
To Next Page
Loading...
Need help?
General
