Tiesse Imola LX 5200 User Manual

ADSL interface
USER GUIDE
62
set adsl encap pppoa-llc|pppoa-vcmux|pppoe-llc|pppoe-vcmux rfc1483-llc|rfc1483-vcmux
In order to configure the number and type of PVC the command is:
set adsl pvc_number <value>
set adsl pvc atmX vpi <value> vci <value>
pvc_number can have a maximum value of 8
6
and atmX will be atm0, atm1,…atm7. The default
value of pvc_number is 1.
In order to configure vpi (value 8) and vci (value 35):
set adsl pvc atm0|…|atm7 vpi <value> vci <value> [pcr <value>]
If the encapsulation type is rfc1483-vcmux or rfc1483-llc (protocols described in RFC 1483,
Multiprotocol Encapsulation over ATM Adaptation Layer 5) it is necessary to define an IP address
through the command:
set adsl pvc atm0|…|atm7 ipaddr <value>
To remove the IP address:
set adsl pvc atm0|…|atm7 no-ipaddr
Otherwise, according to the information received from the Service Provider, the following
commands could be used:
set adsl pvc atm0|…|atm7 ipaddr <value>
set adsl pvc atm0|…|atm7 nexthop
set adsl pvc atm0|…|atm7 netmask <value>
set adsl pvc atm0|…|atm7 mtu <value>
In order to assign an IPv6 address the command is:
set adsl pvc atm0|…|atm7 ipv6addr X:X::X:X/M
A default route could be required:
set adsl pvc atm0|…|atm7 default-route
To enable NAT functions:
set adsl pvc atm0|…|atm7 masquerade
And to remove the options:
set adsl pvc atm0|…|atm7 no-ipaddr
set adsl pvc atm0|…|atm7 no-nexthop
set adsl pvc atm0|…|atm7 no-mtu
set adsl pvc atm0|…|atm7 no-default-route
set adsl pvc atm0|…|atm7 no-masquerade
When PPPoA (PPP over ATM) or PPPoe (PPP over Ethernet) encapsulation types are used, the login
and password for authentication must be defined:
set adsl login <value> password <value>
It is possible to configure the type of ATM traffic per PVC as follows:
6
-
PPPoA and PPPoE connections can only have a single PVC.

Tiesse Imola LX 5200 Specifications

General

Brand	Tiesse
Model	Imola LX 5200
Category	Network Router
Language	English