EasyManuals Logo

Tiesse Imola LX 5200 User Manual

Default Icon
376 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #51 background imageLoading...
Page #51 background image
ISDN interface
USER GUIDE
51
allows to specify a list of permissible callers from which accepting ISDN calls (Calling Line
Identification).
set isdn dialer ippp0 no-in-number
allows to accept calls from any caller.
set ppp login <user> password <password>
can be used to populate the user authentication database.
The database will be used during the authentication of incoming and outgoing calls.
In order to verify the dialer configuration just set, the command is:
show interface isdn dialer ippp0
The output is shown in the following figure:
root@Imola> show interface isdn dialer ippp0
Current setup of interface 'ippp0':
EAZ/MSN: *
Phone number(s):
Outgoing: 0125629552
Incoming:
Dial mode: manual
Secure: off
Callback: off
Reject before Callback: off
Callback-delay: 5
Dialmax: 1
Hangup-Timeout: 60
Incoming-Hangup: on
ChargeHangup: off
Charge-Units: 0
Charge-Interval: 0
Layer-2-Protocol: hdlc
Layer-3-Protocol: trans
Encapsulation: syncppp
Login: pppuser
Accept Remote IP: yes
Set Local IP: no
Default Route: no
Masquerade: no
---------------------------------------
ippp0 is not connected
8: ippp0: <POINTOPOINT,NOARP,UP> mtu 1500 qdisc pfifo_fast qlen 30
link/ppp
RX: bytes packets errors dropped overrun mcast
0 0 0 0 0 0
TX: bytes packets errors dropped carrier collsns
0 0 0 0 0 0
The configuration of a dialer map which can only make outgoing calls can be set with the following
commands:
set isdn dialer ippp1 eaz 999999

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tiesse Imola LX 5200 and is the answer not in the manual?

Tiesse Imola LX 5200 Specifications

General IconGeneral
BrandTiesse
ModelImola LX 5200
CategoryNetwork Router
LanguageEnglish

Related product manuals