7 TopAccess Administrator Mode
152 Setting up from TopAccess
Setting up the POP3 Network Service
In POP3 Network Service, you can specify the POP3 server to receive an Internet Fax and
Emails.
1) Enable POP3 Client
Select whether retrieving an Internet Fax and an Email from the POP3 server is enabled or
disabled.
2) Enable SSL
Select whether the SSL (Secure Sockets Layer) is enabled or disabled for POP3 transmis-
sion.
- Disable
— Select this to disable the SSL for POP3 transmission.
- Verify with imported cert — Select this to enable the SSL using the imported CA certif-
icate.
- Accept all certificates without CA — Select this to enable the SSL without using
imported CA certificate.
y When “Verify with imported cert” is selected, you must import the CA certificate in this
equipment.
P.157 “Setting up the Security Service”
y Not all operating systems support SSL for all protocols.
3) POP3 Server Address
Enter the IP address or FQDN (Fully Qualified Domain Name) of the POP3 server when
“Enable POP3 Client” is enabled.
If you use FQDN to specify the POP3 server, you must configure the DNS server and enable
the DNS in the DNS Session.
When the “Obtain a POP3 Server Address automatically” option is enabled in the TCP/IP
settings, the POP3 server address can be obtained using the DHCP server.
P.132 “Setting up the TCP/IP”
1
2
3
4
5
6
7
8
9
10
To Next Page
Loading...
Need help?
General
