7 TopAccess Administrator Mode
156 Setting up from TopAccess
Setting up the SNMP Network Service
In SNMP Network Service, you can enable or disable the SNMP to monitor the device status
using a network monitoring utility. If an administrator wants to monitor the device status with a
monitoring utility, programmed to fit the MIB, you must enable the SNMP and SNMP Traps.
1) Enable SNMP
Select whether the SNMP monitoring with MIB is enabled or disabled. This must be enabled
to allow users to connect using TopAccessDocMon, TWAIN driver, File Downloader, and the
Address Book Viewer.
2) Read Community
Enter the SNMP read community name for the SNMP access.
y If you specify a community name other than “public” for the Read Community, the appli-
cations that use MIB (TopAccessDocMon, TWAIN driver, File Downloader, and Address
Book Viewer) will be unavailable. The SNMP communication of the printer driver also will
be unavailable, so that the obtaining the configurations, confirming the department code,
and obtaining the available boxes in e-Filing will be disabled.
y When you set the “Read Community” option blank, the SNMP communication between
the SNMP Browser of Client computer and this equipment will be disabled.
1
2
3
4
5
6
7
8
To Next Page
Loading...
Need help?
General
