E6582062
5-11 5. [Fundamental operation] How to use parameters
3
4
5
9
Memo
• Frequencies under the setting value of <F240: Start frequency> are not output. --> Refer to [6.
7. 1].
• During operation of the stall prevention, the inverter may run at the frequency exceeding the
value of <UL: Upper limit frequency> or the frequency under the value of <LL: Lower limit
frequency>.
100%
Output frequency (Hz)
Frequency command
signal (%)
0 100%
Output frequency (Hz)
Frequency command
signal (%)
0
Upper limit frequency Lower limit frequency
<FH>
<UL>
<FH>
<LL>
To Next Page
Loading...
