E6582062
5. [Fundamental operation] How to use parameters 5-26
4
5
9
5. 2. 8 Selecting the parameter mode between [Setting
mode] and [Easy mode]
<PSEL: Parameter mode select>
■ Function
Select the display mode of parameter settings between [Setting mode] and [Easy mode].
You can select a mode at power on and use the operation key to switch it or see only [Easy mode].
How to read parameters depends on a mode.
[Easy mode]
• Register frequently set parameters as [Easy mode] parameters in advance. Only the registered
parameters (up to 32) appear.
• Ten parameters are selected in the default setting. You can change them as required.
[Setting mode]
• You can read all parameters in the standard [Setting mode].
■ Parameter setting
■ Selecting a setting value
0: Setting mode at power on
The parameter mode is set to [Setting mode] at power on.
You can use the operation key to switch between [Setting mode] and [Easy mode].
• Operation panel: [ESC] key or [F1] key
For details, refer to [3. 1. 2].
• Extension panel: [EASY] key (if any)
1: Easy mode at power on
The parameter mode is set to [Easy mode] at power on.
You can use the operation key to switch between [Setting mode] and [Easy mode].
• Operation panel: [ESC] key or [F1] key
For details, refer to [3. 1. 2].
• Extension panel: [EASY] key (if any)
2: Easy mode only
The parameter mode is always [Easy mode].
You cannot see the [Setting mode] screen.
Title Parameter name Adjustment range Default setting
PSEL Parameter mode select 0: Setting mode at power on
1: Easy mode at power on
2: Easy mode only
0
1: Easy mode at power on
2: Easy mode only
0.0HzSTOP
15:16
PSEL :Parameter mode select
0: Setting mode at power on
Basic parameter Easy mode
To Next Page
Loading...
