E6582062
6. [Advanced] How to use parameters 6-6
4
4
6
9
Memo
• When you want to output the inversion signal (OFF signal), set "9".
• When a run command (Fwd signal or Rev signal) is OFF, the specified frequency attainment
signal is also OFF.
Reference
• How to operate the operation panel -> Refer to [3. 1. 1.
• How to switch display mode on the operation panel -> Refer to [3. 1. 2].
• Procedure to change parameter setting -> Refer to [4. 2. 3].
• Details on operation by external signals -> Refer to [Chapter 7].
To Next Page
Loading...
