E6582062
6. [Advanced] How to use parameters 6-126
4
4
6
9
Detection is not performed at auto-restart.
An output phase loss is detected at auto-tuning regardless of the setting for <F605: Output phase
loss detection>.
Memo
•
If <Pt: V/f Pattern> = "5" and "6" is set, 3-phase loss at <F605
>="3", or "4", and <F605>="5" will
be disabled.
• For special motors such as high-speed motors, detection error may occur.
Reference
• How to operate the operation panel -> Refer to [3. 1. 1].
• How to switch display mode on the operation panel -> Refer to [3. 1. 2].
• Procedure to change parameter setting -> Refer to [4. 2. 3]
• Details on operation by external signals -> Refer to [Chapter 7].
To Next Page
Loading...
