E6582062
6. [Advanced] How to use parameters 6-170
4
4
6
9
■ Operation example
<F707> = "0.00: Disabled"
By rotating the touch wheel by 1 step, the panel run frequency command value changes only by 0.1
Hz.
<F707> = "10.00"
Rotating the touch wheel by 1 step changes the panel run frequency command value in 10.00 Hz
increments, from 0.00 up to 60.00 (Hz).
<F707> = "1.00", <F708> = "1"
By rotating the touch wheel by 1 step, the frequency command value changes in steps of 1Hz: 0 1
2 ... 60 (Hz) and also the value displayed on the LCD panel changes in steps of 1.
Use these settings to hide decimal fractions.
Reference
• How to operate the operation panel -> Refer to [3. 1. 1].
• How to switch display mode on the operation panel -> Refer to [3. 1. 2].
• Procedure to change parameter setting -> Refer to [4. 2. 3]
To Next Page
Loading...
