E6581158
F-12
6
, Only one function can be assigned to terminals FLA-FLB-FLC at a time.
(3) Assigning two functions to a group of terminals
A signal is sent out when either of the two functions assigned is activated.
Terminal
symbol
Title
Function
Adjustment range Default setting
RY - RC
H
Output terminal selection 1A 4 (Low-speed de-
tection signal)
OUT - NO
H
Output terminal selection 2A 6 (Designated fre-
quency reach)
RY - RC
H
Output terminal selection 1B 255 (Always ON)
OUT - NO
H
Output terminal selection 2B
0〜255
(See section 11.)
255 (Always ON)
RY - RC/
OUT - NO
H
Output terminal logic selection
0 : H and H
H and H
1 : H or H
H and H
2 : H and H
H or H
3 : H or H
H or H
0
, Two different functions can be assigned to terminals RY-RC and terminals OUT-NO.
, If parameter H is set to , a signal will be sent out when either of the two functions assigned is acti-
vated.
Terminals RY-RC: Send out a signal when either of the functions set with H and H is activated.
Terminals OUT-NO: Send out a signal when either of the functions set with H and H is acti-
vated.
, Timing chart
ON
OFF
ON
OFF
ON
OFF
H
(F137)
H
(F138)
RY-RC output
(OUT-NO)
, Only one function can be assigned to terminals FLA-FLB-FLC at a time.
(4) Assigning two functions to a group of terminals
The logical product (AND) or logical sum (OR) of the two functions assigned is put out as a signal.
To Next Page
Loading...
