User Interface (UI)
T2-C User Guide 85
• TOF offset (mm): Top Of From (top of label) can be +/- depending on moving the top
of the image up or down on label. NOTE: limits -160mm to +160mm
• BOF offset (mm): Bottom of Form (bottom of label) can be +/- depending on moving
the bottom of the image up or down on label. NOTE: limits 0mm to 100mm
• Left offset (mm): Move printed image towards left or right compared to the left edge
of the printhead. NOTE: limits -127mm to 222mm
• Square meter/Label cost: Price of one label for die cut material. Square meter price
for Continuous and Blackmark label material. Used for total cost/label calculation. See
“Statistics menu” on page 70.
• Gap size: Setting the gap size between printed labels.
Note: Maximum gap is 65mm.
Note: Gap size field is only displayed if TOF mode is continuous. In diecut and
blackmark modes, the label eye sensor detects the label gaps/blackmarks.
To Next Page
Loading...