Trojan T2-C User Manual

User Interface (UI)
86 T2-C User Guide
Important: There is a minimum gap required to be able to print in continuous mode!
See “Gap size and speeds” on page 50.
Setting the gap size to 0mm in continuous mode will result in an error state. For gapless
printing use the stitch mode option. See “Driver features and functions” on page 56.
Media Settings Advanced
• Minimum unwinder diameter (mm): When roll diameter reaches the minimum
unwinder diameter value, the printing will be paused and new label roll can be loaded
and spliced. This sensor setting is to avoid running out of label material during a print
job.
• Unwinder torque (N): Tension for the unwinder. Minimum value is 10, maximum value
is 50.
• Rewinder torque (N): Tension for the rewinder. Minimum value is 10, maximum value
is 85.
Icon Description
Save and apply
Save settings to a media profile
Delete a media profile
Media profiles list

Trojan T2-C Specifications

General

Brand	Trojan
Model	T2-C
Category	Label Maker
Language	English