Need help?Do you have a question about the TSAT 3000 and is the answer not in the manual?
General| Brand | TSAT |
|---|---|
| Model | 3000 |
| Category | Microphone system |
| Language | English |
Configures communication ports, defining type, socket, COM, and data transfer settings.
Sets the number of logical ports.
Sets the type of data on this PORT.
Sets the SOCKET connection to this PORT.
Sets the COM connection to this PORT.
Bit field to control miscellaneous PORT options.
Defines destination Unit(s) for User-Data.
Defines PORT(s) for User-Data destination.
Sets number of SOCKETs.
Sets Type of data on this SOCKET.
Sets Transport-Protocol for this SOCKET.
Sets ADDRESS associated with this SOCKET.
Sets LOCAL-PORT associated with this SOCKET.
Sets REMOTE-PORT associated with this SOCKET.
Bit field to control miscellaneous SOCKET options.
Sets number of Local-COMs.
Bit field to control miscellaneous COM options.
Sets IP-ADDRESS of Ethernet/Satellite interfaces.
Sets SUBNET-MASK of Ethernet/Satellite interfaces.
Sets IP-ADDRESS and SUBNET-MASK of Ethernet/Satellite interfaces.
Defines routing of IP packets.
Reads onboard A/D-Converters values.
Reads/writes onboard D/A-Converters values.
Modifies TCXO/OCXO Oscillator settings.
Enable/disable various signal and power switches.
Controls the "Automatic Tx-Gain Control (AGC)" facility.
Sets Tx-Gain DAC value.
Controls the "End-to-End Tx-Gain" facility.
Defines min/max Tx-Gain DAC values for AGC.
Sets Rx-Attenuator DAC value.
Sets max packets stored in satellite link Transmission-Queue.
Controls "Slot Request and Reservation" facility.
Sets maximum number of RTs in the network.
Sets the identifier of an RT or HUB.
Enables "Pulse Position Reservation (PPR) Facility".
Sets Slot Phase Setpoint for packet timing.
Sets HUB TX frequency.
Sets RT TX frequency.
Adjusts RT’s transmitting frequency for HUB reception.
Enables Main-Unit Power-Save SLEEP function.
Identifies the CCU as HUB or RT.
To Next Page