TSAT 3000 - 3.11.3 PHL_{OUTBOUND | INBOUND}_FECRATE; 3.11.4 PHL_{OUTBOUND | INBOUND}_FECTYPE

TSAT 3000 - Telemetry and data transfer via SATellite
TSAT 3000 Configuration Parameter Description, January 2013 Page 75 of 124
3.11.3 PHL_{OUTBOUND | INBOUND}_FECRATE
Default 4, Range 1…5
Set FEC-Rate for Outbound PHL_TX_HUB_FREQUENCY carrier.
Set FEC-Rate for Inbound
PHL_TX_RT_FREQUENCY carrier.
Value Description
1 None
2 7 / 8
3 3 / 4
4 1 / 2
5 1 / 3
Note: DSP will be restarted 10 seconds after you’ve changed CURRENT value.
Ver >= 30.8.0: Restart of DSP is enabled by bit 2 (0x0004) in
UTL_UTILITY_MASK.
3.11.4 PHL_{OUTBOUND | INBOUND}_FECTYPE
Default 2, Range 1…4
Set FEC-Type for Outbound PHL_TX_HUB_FREQUENCY carrier.
Set FEC-Type for Inbound
PHL_TX_RT_FREQUENCY carrier.
Value Description
1 Uncoded
2 Viterbi
3 Vitreed
4 Turbo
Note: DSP will be restarted 10 seconds after you’ve changed CURRENT value.
Ver >= 30.8.0: Restart of DSP is enabled by bit 2 (0x0004) in
UTL_UTILITY_MASK.