TSAT 3000 - 3.14 SYSTEM PARAMETERS; 3.14.1 SYS_IS_HUB

TSAT 3000 - Telemetry and data transfer via SATellite
TSAT 3000 Configuration Parameter Description, January 2013 Page 105 of 124
3.14 SYSTEM PARAMETERS
3.14.1 SYS_IS_HUB
Default 0, Range 0…1 – BOOT
Identifies the CCU as HUB or RT
Value Description
0 RT
1 HUB
Note: You cannot change this parameter via satellite link, but must be connected locally.
3.14.2 SYS_COPYRIGHT
Read-Only
Contains the following Read-Only null-terminated text string:
“(C) TSAT “
3.14.3 SYS_HW_REVISION
Read-Only
Identifies the Hardware revision.
Ver <= 30.1.1:
Not used. Value is always zero.
Ver >= 30.2.0:
Value Description
–1 Unknown revision
ELSE Revision n (0, 1, ….)
3.14.4 SYS_CONFIG_VERSION
Read-Only
Contains a Read-Only null-terminated text string as defined in SYS_VERSION – identifying the
software version of the CCU that saved the Configuration SAT file currently used.
RT Ver >= 30.1.0:
When Backup-Configuration is used, the text “(Backup)” will be appended to the version-
string.