TSAT 3000 - Telemetry and data transfer via SATellite
TSAT 3000 Configuration Parameter Description, January 2013 Page 85 of 124
3.11.14 PHL_{OUTBOUND | INBOUND}_IDENTITY
Ver <= 30.4.1: OUTBOUND – Default 875, Range 0…65534
INBOUND – Default 850, Range 0…65534
Ver >= 30.5.0: OUTBOUND – Default 100, Range 0…65534
INBOUND – Default 200, Range 0…65534
Set carrier identifier for Outbound PHL_TX_HUB_FREQUENCY carrier.
Set carrier identifier for Inbound
PHL_TX_RT_FREQUENCY carrier.
These identifiers must be set alike for the HUB and all RTs using the same carriers. They are
used to prohibit the HUB and RTs to lock to a carrier of another TSAT system with frequencies
within its search range.
Value 65535 (0xFFFF) is reserved, and cannot be assigned to these MIBs.
Note: DSP will be restarted 10 seconds after you’ve changed CURRENT value.
Ver >= 30.8.0: Restart of DSP is enabled by bit 2 (0x0004) in
UTL_UTILITY_MASK.
3.11.15 PHL_{OUTBOUND | INBOUND}_IDENTITY_BKUP
Default 0, Range 0…65534 – No-Current
Ver == 30.0.0
Not Used.
Ver >= 30.1.0
HUB: Not Used.
RT: Set carrier identifiers for Outbound (
PHL_TX_HUB_FREQUENCY_BKUP) and Inbound
(
PHL_TX_RT_FREQUENCY_BKUP) carriers to/from Backup-HUB.
3.11.16 PHL_INBOUND_IDENTITY_2
Default 0, Range 0…65534
Ver <= 30.7.0
Not Used.
Ver >= 30.8.0 + RT DSP >= 2.3.1
Set carrier identifier for Secondary Inbound
PHL_TX_RT_FREQUENCY_2 carrier from Multi-
Inbound-Link (MIL) RT to Slave-HUB.
Note: Ver >= 30.6.0: DSP will be restarted 10 seconds after CURRENT value is changed.
Ver >= 30.8.0: Restart of DSP is enabled by bit 2 (0x0004) in
UTL_UTILITY_MASK.
3.11.17 PHL_INBOUND_IDENTITY_2_BKUP
Default 0, Range 0…65534 – No-Current
Ver <= 30.7.0
Not Used.
Ver >= 30.8.0 + RT DSP >= 2.3.1
Set carrier identifier for Secondary Inbound Backup
PHL_TX_RT_FREQUENCY_2_BKUP carrier
from Multi-Inbound-Link (MIL) RT to Backup-Slave-HUB.
To Next Page
Loading...