TSAT 3000 - Telemetry and data transfer via SATellite
TSAT 3000 Configuration Parameter Description, January 2013 Page 40 of 124
3.4 IP PARAMETERS
3.4.1 IP_ADDRESS_{ETH1 | ETH2 | SAT}
Default <nothing>
Ver <= 30.1.1
Set IP-ADDRESS of Ethernet-A, Ethernet-B and Satellite interfaces.
Note: These MIB parameters are only partly implemented:
• You may read and change FILE value, but this will have no
effect. The Main-Unit will
always boot with values defined in “system.conf”.
• Read CURRENT value will fetch current values from IP-STACK.
• Write CURRENT value will configure IP-STACK with new IP-ADDRESS.
Ver >= 30.2.0
Not Implemented – Parameter is replaced by
IP_ADDRESS_{LANA | LANB | SAT}.
3.4.2 IP_SUBNET_MASK_{ETH1 | ETH2 | SAT}
Default <nothing>
Ver <= 30.1.1
Set SUBNET-MASK of Ethernet-A, Ethernet-B and Satellite interfaces.
Note: These MIB parameters are only partly implemented:
• You may read and change FILE value, but this will have no
effect. The Main-Unit will
always boot with values defined in “system.conf”.
• Read CURRENT value will fetch current values from IP-STACK.
• Write CURRENT value will configure IP-STACK with new IP-ADDRESS.
Ver >= 30.2.0
Not Implemented – Parameter is replaced by
IP_ADDRESS_{LANA | LANB | SAT}.
To Next Page
Loading...