TSAT 3000 - Telemetry and data transfer via SATellite
TSAT 3000 Configuration Parameter Description, January 2013 Page 86 of 124
3.11.18 PHL_TX_HUB_FREQUENCY
Ver <= 30.4.1: Default 14.239.875, Range 14.000.000…14.500.000
Ver >= 30.5.0: Default 14.240.100, Range 5.000.000…14.500.000
Set the HUB TX frequency in kHz.
Note: DSP will be restarted 10 seconds after you’ve changed CURRENT value.
Ver >= 30.8.0: Restart of DSP is enabled by bit 2 (0x0004) in
UTL_UTILITY_MASK.
3.11.19 PHL_TX_RT_FREQUENCY
Ver <= 30.4.1: Default 14.239.850, Range 14.000.000…14.500.000
Ver >= 30.5.0: Default 14.240.200, Range 5.000.000…14.500.000
Set the RT TX frequency in kHz.
Note: DSP will be restarted 10 seconds after you’ve changed CURRENT value.
Ver >= 30.8.0: Restart of DSP is enabled by bit 2 (0x0004) in
UTL_UTILITY_MASK.
3.11.20 PHL_TX_HUB_FREQUENCY_BKUP
Ver <= 30.4.1: Default 0, Range 0 + 14.000.000…14.500.000 – No-Current
Ver >= 30.5.0: Default 0, Range 0 + 5.000.000…14.500.000 – No-Current
Ver == 30.0.0
Not Used.
Note: The value must
be zero for correct RT operation (HUB doesn’t care).
Ver >= 30.1.0
HUB: Not Used.
RT: You enable the Backup-HUB functionality by setting this MIB (i.e. the Backup-HUB TX
frequency in kHz) to non-zero value. The RT will switch to receive from this HUB if it
cannot open the link to the Main-HUB. The other Backup-parameters must also be
defined with legal values:
• PHL_TX_RT_FREQUENCY_BKUP
•
PHL_{OUTBOUND | INBOUND}_IDENTITY_BKUP
See also NET_MAX_POLL_SECONDS and PHL_SWITCH_BACK_TO_MAIN_HUB.
3.11.21 PHL_TX_RT_FREQUENCY_BKUP
Ver <= 30.4.1: Default 0, Range 0 + 14.000.000…14.500.000 – No-Current
Ver >= 30.5.0: Default 0, Range 0 + 5.000.000…14.500.000 – No-Current
Ver == 30.0.0
Not Used.
Ver >= 30.1.0
HUB: Not Used.
RT: The RT TX frequency to Backup-HUB in kHz. The RT will switch to receive from this
HUB if it cannot open the link to the Main-HUB.
Setting
PHL_TX_HUB_FREQUENCY_BKUP to zero disables this functionality.
See also
NET_MAX_POLL_SECONDS and PHL_SWITCH_BACK_TO_MAIN_HUB.
To Next Page
Loading...