TSAT 3000 - 3.5.2 ADC_{1 | 2 | 3 | 4 | 5 | 6 | 7 | 8}_XXX; 3.5.3 DAC_{11 | 12 | 13 | 14 | 21 | 22 | 23 | 24}_XXX

TSAT 3000 - Telemetry and data transfer via SATellite
TSAT 3000 Configuration Parameter Description, January 2013 Page 48 of 124
3.5.1 ADC_SAMPLE_COUNT
Default 1, Range 1…100
Used when the operator fetch a measurement from one of onboard A/D-Converters: ADC_{1 | 2 |
3 | 4 | 5 | 6 | 7 | 8}_XXX
. The A/D-Converter will be read the specified number of times, and the
average value returned.
3.5.2 ADC_{1 | 2 | 3 | 4 | 5 | 6 | 7 | 8}_XXX
Read-Only
You can read the CURRENT value of all onboard A/D-Converters (12-bits). Each time you fetch a
value, the A/D-Converter will be read
ADC_SAMPLE_COUNT number of times, and the average
value returned.
The MIB names describe the usage of the A/D-Converter:
• ADC_1_TX_RF_LEVEL
• ADC_2_RX_RF_LEVEL
• ADC_3_TCXO_VOLTAGE Ver <= 30.1.1: MIB is called
ADC_3_TXCO_VOLTAGE.
• ADC_4_RX_IF_LEVEL Ver <= 31.0.1: MIB is called
ADC_4_TX_GAIN.
• ADC_5_BUC_VOLTAGE
• ADC_6_LNB_VOLTAGE
• ADC_7_LNB_CURRENT
• ADC_8_BUC_CURRENT
See also
GAIN PARAMETERS.
3.5.3 DAC_{11 | 12 | 13 | 14 | 21 | 22 | 23 | 24}_XXX
Default 0, Range 0…4095 (0x0FFF) – Volatile
You can both read and write the CURRENT value of all onboard D/A-Converters (12-bits).
The MIB names describe the usage of the D/A-Converter:
• DAC_11_TCXO_REF_HIGH
• DAC_12_TCXO_REF_LOW
• DAC_13_OCXO_REF_HIGH
• DAC_14_OCXO_REF_LOW
• DAC_21_TX_GAIN
• DAC_22_RX_VGA1
• DAC_23_RX_VGA2
• DAC_24_RX_ATT
See also
GAIN PARAMETERS.