TSAT 3000 - Telemetry and data transfer via SATellite
TSAT 3000 Configuration Parameter Description, January 2013 Page 96 of 124
3.11.29 PHL_SAT_CONVERT_FREQUENCY
Ver <= 30.4.1: Default 1.500.000, Range 500.000…5.000.000
Ver >= 30.5.0: Default 1.500.000, Range 1.000.000…5.000.000
Set the satellite conversion frequency [kHz]. The MIB value must match the used satellite.
Typically values are 1.500.000 or 2.800.000 [kHz]
Note: DSP will be restarted 10 seconds after you’ve changed CURRENT value.
Ver >= 30.8.0: Restart of DSP is enabled by bit 2 (0x0004) in
UTL_UTILITY_MASK.
3.11.30 PHL_FE_RX_LO
Ver <= 30.4.1: Default 11.300.000, Range 5.000.000…20.000.000
Ver >= 30.5.0: Default 11.300.000, Range 2.000.000…16.000.000
Set the RX (LNB) Local Oscillator frequency [kHz]. The MIB value must match the connected
LNB. Currently the following LNBs are used with TSAT 3000 Main Unit:
LNB – TSAT Part No
PHL_FE_RX_LO
[kHz]
RX 1410 A 11.300.000
RX 1410 B 10.000.000
RX 1410 C 10.750.000
Note: DSP will be restarted 10 seconds after you’ve changed CURRENT value.
Ver >= 30.8.0: Restart of DSP is enabled by bit 2 (0x0004) in
UTL_UTILITY_MASK.
3.11.31 PHL_FE_TX_LO
Ver <= 30.4.1: Default 13.050.000, Range 5.000.000…20.000.000
Ver >= 30.5.0: Default 13.050.000, Range 2.000.000…16.000.000
Set the TX (BUC) Local Oscillator frequency [kHz]. The MIB value must match the connected
BUC. Currently the following BUC is used with TSAT 3000 Main Unit:
BUC – TSAT Part No
PHL_FE_RX_LO
[kHz]
TX 1414 C 13.050.000
Note: DSP will be restarted 10 seconds after you’ve changed CURRENT value.
Ver >= 30.8.0: Restart of DSP is enabled by bit 2 (0x0004) in
UTL_UTILITY_MASK.
To Next Page
Loading...