TSAT 3000 - COM_SIGNAL_DATA_DELAY [N]; COM_SIGNAL_HOLD [N]

TSAT 3000 - Telemetry and data transfer via SATellite
TSAT 3000 Configuration Parameter Description, January 2013 Page 38 of 124
3.3.4 COM_SIGNAL_DATA_DELAY [n]
Default 0, Range 0…60000
Ver <= 30.7.0
Not Implemented.
Ver >= 30.8.0
Controls the timing of COM’s DSR output signal (pin 6) when
COM_SIGNAL_OUT [n] is 4 or 5.
In this case, DSR will be set ON COM_SIGNAL_DATA_DELAY milliseconds (max 1 minute)
before
the first byte of data is transmitted to the COM port.
Note: The actual delay will be between 0 and 17 ms larger than the specified value.
3.3.5 COM_SIGNAL_HOLD [n]
Default 0, Range 0…60000
Ver <= 30.7.0
Not Implemented.
Ver >= 30.8.0
Controls the timing of COM’s DSR output signal (pin 6) when
COM_SIGNAL_OUT [n] is 4 or 5.
In this case, DSR will be kept ON while data is transmitted to COM port, and turned OFF
COM_SIGNAL_HOLD milliseconds (max 1 minute) after the last byte of data have been
transmitted to the COM port.
Note: The actual hold time will be between 0 and 17 ms larger than the specified value.