EasyManuals Logo

Unipulse F701+ User Manual

Unipulse F701+
149 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
3
1 Before Getting Started
3
Before Getting Started
Chapter
1
Caution
Do not install the product in the following environments:
- Locations where temperature or humidity exceeds specifications;
- Locations subject to drastic temperature fluctuations or icing and condensation;
- Outdoors or locations above 2,000m;
- Locations exposed to direct sunlight;
- Locations subject to dust accumulation;
- Locations with poor ventilation;
- Locations with a lot of salt and m
etal powder;
- Locations where the main unit is subject to direct vibration and/or shock.
Perform adequate shielding if the product is used in the following locations:
- Near power lines;
- Locations subject to strong electric and/or magnetic field;
- Locations subject to noise such as static electricity and relays.
Install as far away as possible from equipment generating high frequency, high voltage
,
large current, surge, etc. Moreover, perform wiring of cables separately from these power
lines. Do not perform parallel wiring and identical wiring.
Do not use the product if it is damaged.
Use shielded cables for cables (load cell, external I/O, SI/F, optional interface).
Avoid a temporary overvoltage exceeding 1500V to be applied to the power source.
Be sure to allow an interval of five seconds
or longer between turning power ON and OFF.
Use after warming up for 30 minutes or longer following the startup of power supply.
Protective performance of the F701+ may be lost if it is not used as specified.
Cleaning
- Unplug the power supply when cleaning.
- Do not wipe with a wet cloth, benzine, thinner, alcohol, etc. This may lead to discoloration
and/or warping of the F701+. When dirty, clean
using a well squeezed cloth soaked in
diluted neutral detergent. Afterwards wipe with a soft, dry cloth.
When sending the F701+ to us for repair and so on, pack it with sufficiently shock-absorbing
materials.
Handle this product as industrial waste when disposing.
Events that may cause injury to persons or material damage
in cases of misuse.
Installation precautions
Wiring precautions
Startup/maintenance precautions
Transportation precautions
Disposal precautions

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Unipulse F701+ and is the answer not in the manual?

Unipulse F701+ Specifications

General IconGeneral
BrandUnipulse
ModelF701+
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals