118
6 Useful Functions
118
Useful Functions
Chapter
6
6-15. Connecting a printer
The F701+ can be connected to a printer to print weight values and so on in real time.
6-15-1.Printer mode
Set the baud rate (setting mode 4-4: RS-232C communication setting) to 6: printer mode. By simply
changing to printer mode, the settings change automatically within the device to enable it to
communicate with the printer in use. Other communication conditions are
not relevant. Printing will
not be carried out properly unless the device is set to printer mode. Furthermore, the printer to be
connected to must be ONLINE to print.
When the device is set to printer mode, the following communication settings will be applied. Check
the communication settings for the printer to be connected before using it.
Baud rate 4800 bps
Character length 8 bits
Parity bit None
Stop bit 1
bit
6-15-2.Printer settings
■ Print settings
Perform setting related to printing.
■ Printer command
Perform setting related to printer commands.
[Print settings] (setting mode 7-1)
* Undefined
Near zero print
Auto print
1: ON
0: OFF
* Undefined
1: ON
(manual print OFF)
0: OFF
(manual print ON)
[Printer command] (setting mode 7-2)
4: Paper feed
3: Date print
2: Erase print
1: Total print
0: Cancel
To Next Page
Loading...
Need help?
General
