96
6 Useful Functions
96
Useful Functions
Chapter
6
Holding register
4XXXX
40045 Gen. Stan. Dev. (HI) (read only)
No sign 32 bit
40046 Gen. Stan. Dev. (LO) (read only)
40047 Smp. Stan. Dev. (HI) (read only)
40048 Smp. Stan. Dev. (LO) (read only)
40049 Max. - min. (HI) (read only)
40050 Max. - min. (LO) (read only)
40051 Latest accumulation data (HI) (read only)
40052 Latest accumulation data (LO) (read only)
40053 Accumulated value (HI) (read only)
40054 Accumula
ted value (LO) (read only)
40055
to
40058
Backup (not allocated)
40059 Compensation
No sign 16 bits
40060 Over
40061 Under
40062 Comparison inhibit time 1
40063 Comparison inhibit time 2
40064 Judging time
40065 Complete output time
40066 Compensation feeding time
40067 Number of times for AZ
40068 Number of times for judging
40069 Weighing function 1
40070 Weighing function 3
40071 Sequence mode
40072 Function key inhibited
40073 F
ilter
40074 MD (time - range)
40075 ZT (time - range)
40076 DZ regulation value
40077 Function selection
40078 D/A output mode
40079 Moving average filter
40080 Measurement Act compliance
40081 Output selection
40082 Restart setting Set point 1
40083 Restart setting Set point 2
40084 Restart setting Set point 3
40085 Number of times for knocking
40086 Knocking time
40087 Number of digits for accumulated display
40088 Min. scale d
ivision
40089 Set value LOCK
40090 Number of data (read only)
40091
to
49999
Backup (not allocated)
The address nos. used in messages are relative addresses.
Relative addresses are obtained using the formula below.
Relative address = last 4 digits of the address no. -1
For example, relative address is 0014 (0x0E) when 40015 is specified for the hold-
ing register.
Key point
To Next Page
Loading...
Need help?
General
