Smart Plus (PHT-35LHS)
Technical Manual
VT-TECH-Smart Plus-001
COPYRIGHT© 2018 VATECH.
7) Set the parameters as shown below and click CONFIRM.
8) Click READY when enabled and acquire the image according to the Console Software
guidance and save the image in a 2D Viewer (EzDent-I or EasyDent 4).
9) Run EzEval.exe and click the CT Image Evaluation tab.
EzEval.exe path: C:\VCaptureSW\Util\EzEval_Phantom
10) Click brw, browse a captured slice image and open it.
Slice image path: C:\VCaptureSW\Acquisition\CBCT\WidePano\SLICE
To Next Page
Loading...
