Smart Plus (PHT-35LHS)
Technical Manual
VT-TECH-Smart Plus-001
COPYRIGHT© 2018 VATECH.
3. Equipment Safety Instructions
This electro-medical device contains high voltage and current flowed parts, and the following
instruction must be followed to avoid critical damage to the body and equipment.
Electrical Safety Caution
The equipment and PC should be connected to a common protective
earth. Confirm that the equipment is well-grounded.
High voltage and current flows throw equipment. Turn off equipment
power and wait at least 2 minutes before the operation begins.
Do not connect this equipment to any devices without authorization from
Vatech. Inc.
Do not connect this equipment to a Multiple Portable Socket- Outlet
(MPSO) or extension wires
Keep in mind that MCU boards are electrically sensitive that operators
need to wear shielding gloves during operation.
The only part that can be replaced by the users is the input fuses. Check
if the fuses comply with the manufacturer’s specifications.
Mechanical Safety Caution
Ensure that your fingers or any part of your body are shut in the
equipment.
Press the emergency stop button to stop the equipment when a problem
occurs during the operation. The equipment will be cut off from the
power as you press the button.
Do not touch the patient while touching the SIP or SOP connector.
Ensure that the patient’s eyes directly contact the laser beam when you
are guiding his or her position.
Never expose the equipment to liquids, mists, or sprays. They can
cause electrical accidents such as an electric shock or system damage.
Do not use spray cleaners on the equipment to avoid fire.
Do not use solvent aerosol or spray cleaning agents directly on the
surface of the equipment. It can damage equipment including the LCD
panel.
.
To Next Page
Loading...
Need help?
General
