Error Messages
VTK-TR-BA-072e-1 - User Manual MDS 358X Series
11 Error Messages
The following pages list all the error messages you could encounter when using this system. The
table in paragraph 11.1, page 141 will give you a quick overview. In paragraph 11.2, page 142
every error message is explained in detail.
In case of an error, an error message is shown in the display and the red attention LED is switched
“ON“. This information can also be obtained via pin 13 of the PLC interface (see paragraph 8.2.1
"Pin Functions", page 113). Press [enter] to clear the display. If this does not work, switch “OFF”
the control unit. Check the system for potential problems (e.g. loose cables) and re-start the
system.
If the error still occurs, please contact the Technical Support at VERMES Microdispensing or your
local supplier (see Page 7).
INFORMATION
Storing error messages
After the re-start, the error message can only be found in the submenu “Error” (see
paragraph 4.5.4 "Submenu “Status”", page 34).
INFORMATION
Valve status depending on error
If the valve is open or closed after an error message, depends on the respective error. In
paragraph 11.2, page 142 it is mentioned for each error.
To Next Page
Loading...