Vermes MDS 358X - Overview of the Command Functions

Attachments
170
VTK-TR-BA-072e-1 - User Manual MDS 358X Series
14.6 Overview of the Command Functions
Details of the commands listed below are explained in paragraph 8.1.2.2, page 88.
RS-232C commands Functions
1 *ESR? (e.g. 50 errors) Check the latest error codes
2 *ESR2? (e.g. 50 errors) Check the latest error codes with parameters
3 *IDN? Check device information
4 *OPC? Check the last trigger impulses
5 ADJUST:? Check the adjust status
6 ADJUST:START Initiate the adjust
7 ADJUST:OFFSET:? Check current adjust offset value
8 ADJUST:OFFSET:<offset value> Set adjust offset value
9 ADJUST:CALIBRATION:? Check the status of (remote) adjust
10 ADJUST: CALIBRATION:ON Activate the adjust
11 HEATER:? Check the heater status
12 HEATER:ID? Check the information of the connected heater
13 HEATER:OFF Turn off the connected heater
14 HEATER:ON Turn on the connected heater
15 HEATER:TEMP:<target temperature> Set the target temperature for the connected heater
16 HEATER:LIMITS:<min>,<max> Set the limits for the temperature regulation
17 COOLER:? Check the cooling status
18 COOLER:ID? Check the information of the connected flow control valve
19 COOLER:OFF Turn off the connected flow control valve
20 COOLER:ON Turn on the connected flow control valve
21 COOLER:TEMP:<target temperature> Set the target temperature for the cooling
22 COOLER:OFFSET:<offset> Set the cooler offset for the connected flow control valve
23 KEY:ENTER Send ENTER signal to confirm error(s)
24 KEY:ESCAPE Send ESCAPE signal
25 HELP Check all RS-232C commands
26 LCD? Check current content of the screen
27 MAINT:STATUS Check accumulated amount of pulses (in %)
28 MAINT:MESSAGE:OFF Deactivate the maintenance message
29 MAINT:MESSAGE:ON Activate the maintenance message
30 SYSTEM:KLOCK:OFF Unlock the keypad
31 SYSTEM:KLOCK:ON Lock the keypad
32 SYSTEM:SHOW:CYCLES Check the current cycle counter
33 SYSTEM:SHOW:VALVEID Check the valve ID
34 SYSTEM:SHOW:CONTROLLERID Check the MDC ID
35 SYSTEM:SHOW:STATUS
Check the status of KeyLock, DosOK with Delay, SingleDosOK
and Auxiliary Mode
36 SYSTEM:SHOW:ACTTEMP Check the actuator temperature
37 SYSTEM:DOSOKDELAY:OFF Deactivate the DOSOK-Delay