124
Eliminating malfunctions
PowerPush
system [+]
The PowerPush system [+] supports the drive with the help of the ca r-
dan shaft drive when removing a blockage. The knives are therefore
swi vel led out with the AutoPlus-Pilotbox. The tractor is not emptied
when the Power Push system [+] i s used.
Make sure that you increase the PTO shaft speed slowly . Observe the
process. If the sli p clut ch responds, y ou must sw itch off the tractor's
PTO shaft immediately. Damage may be caused to the implement.
Proceed as foll ow s:
> Press the “INFO” button...
> ...until the “Pick-up/Knives” symbol is displayed.
> Press the “GO” button...
> unti l the “Pi ck-up/Kni ves” symbol is selected on the displ ay.
> Swivel out the knives using the tractor's control device and switch
on the tractor's PTO shaft at the same time.
> Check whether the blockage has been cleared.
To Next Page
Loading...
