Eliminating malfunctions
131
Bale chamber
hydrau li c sy stem
Rear fla p
Problem Cause Solution Page
Manom eter indicates a pressure
drop
Leaky pressure valve > Contact a repair specialist:
Clean or replace the valve
Rear flap cylinder not sealed > Contact a repair specialist:
Replace the cylinder seal(s)
Line not sealed > Check and repair leaky tubes
and pipes
Problem Cause Solution Page
Rear flap opens during bale pro-
duction
Rear flap not closed correctly > After the rear flap was closed
using the control device, the
pressure has not built up suf-
ficiently (approximately 3 se-
conds)
> When the rear flap is closed
correctly, check the rear flap
sensor
> Replace the cylinder gaskets
> Clean the rear flap thorough-
ly
Rear flap not completely closed Rear flap dirt y > Clean the rear flap thorough-
ly
To Next Page
Loading...
