130
Eliminating malfunctions
Net wrapping
Problem Cause Solution Page
The servo-motor moves too
slowly
Battery voltage too low > Check the battery
Faulty electrical connections > Check the electri cal connec-
tions
The swivel joint moves with diffi-
culty
> Adjust so that movement i s
unrestricted
Bal e incompletel y wr apped wi th
net
Poor net quality > Use the recommended net
quality
The net does not cover full bale
width
Cone-shaped bal e > Ensure smooth crop flow
Net tension too low > Adjust the net brake
> Adjust the V-bel t for the net
dri ve mechanism
62
105
Net not wound closel y to bal e Bale i nsuffici ent l y wr apped > Increase the number of the
wraps
Insuffici ent brake force > Adjust the net brake
> Adjust the V-bel t for the net
dri ve mechanism
62
105
Net wrapping system remains
inactive
System set to “Manual” mode > Set to “Automatic” mode
No electrical connection > Ensure electrical connection
No signal to net roller sensor > Clean or adjust the net roller
sensor
113
Crop residues behind the net
feed roller
> Remove the soiling
Net tor n befor e ty i ng is complete Net brake power set too high > Remove the fil l i ng di sc(s) i n
the belt pul l ey
Net guidance inadequate > Check the net guide adjust-
ment
Net not cut Knives dirty or damaged > Clean the knives
Mechanical obstruction when
being drawn in
> Check the mechanism
Insufficient power supply > Ensure sufficient power sup-
ply or connect to the battery
directly
No net tension > Increase the net tensi on 62
To Next Page
Loading...
