Preparing for use
51
Fitti ng the kni ves
The knife driving shaft can be accessed via the bale chamber. Please
observe the relevant safety instructions »Working in the bale cham-
ber«, page 49.
> Wh en fitting the kn ive s, hold the ends and insert them into the ova l
holes on top of the knife driving shaft.
> Ensure that the bale chamber is empty at the end of the work.
> Empty the bale chamber.
> Close the rear flap.
→
»Closi ng the rear fl ap«, page 46
Switch off the AutoPlus-Pilotbox.
> Press the “ON/OFF” button.
> Switch off the tractor, take out the ignition key and secure it.
> Push the lev er for the knife driving shaft upwards (to do this, open
the right-hand side door).
> Open the cutterbar ball valve.
Lever for the
knife driving shaft
Cutterbar ball valve
To Next Page
Loading...
