Cause 2:
If a Canbus device specified in the VVSconfig.ini is not found on the Canbus, these CAN
timeout messages are also shown.
Solution 2:
Make sure that all the devices specified in the VVSConfig.ini are present on the Canbus
network:
1. Start Java Canmon.
2. Perform a scan of the Canbus network.
3. Compare the devices found by Java Canmon on the Canbus network with the device
specified in the VVSConfig.ini.
TROUBLESHOOTING
CAN-bus problems
8
THINKING FORWARD
VMI Vision System VVS (OL82) VVSX 13.0.12.0, VVSU 3.0.6 / 4 / 2016-07-11 / pd#175592
8-15
To Next Page
Loading...