VMI VVS OL82 - Holes in the Body-Ply Are Detected by the Camera

leading end tip is on the left-hand side. In case of a negative material angle, the leading
end tip is on the right-hand side.
8.6.2 Holes in the body-ply are detected by the camera
Problem:
Spikes are seen in the material scan of body-ply as can be seen in the material scan below.
Cause:
Sometimes the body‑ply contains holes which are seen by the camera. This results in a
minor deviation of the calculated move to position.
TROUBLESHOOTING
Calculation problems
8
THINKING FORWARD
VMI Vision System VVS (OL82) VVSX 13.0.12.0, VVSU 3.0.6 / 4 / 2016-07-11 / pd#175592
8-27