5-6 Call Operator (Call Attendant)
Cancel
1. Lift handset
2. Dial [#] + [2]
Direct (All Call)
1. Dial [#] + [2] + [2] + [xx]
Where:
xx = destination desired
Follow Me Forward
1. Dial [#] + [2] + [3] + [ss] + [pppp]
Where:
ss = station number to forward to this location
pppp = password of the station to forward
Idle
1. Dial [#] +[2] + [0] + [xx]
Where:
xx = destination desired
No Answer
1. Dial [#] + [2] + [4] + [xx] + [t]
Where:
xx = destination desired
t = time to ring before forwarding; 0 =10 seconds, 1= 20 seconds, 2 = 30 seconds, 3
=40 seconds and 4 =50 seconds).
Call Operator (Call Attendant)
Description
The system Attendant station may be easily called by one dialed digit code. At default,
this code is 0.
Operation
1. Lift handset
2. Dial [0]
Conditions
The code dialed for the system attendant (0 or 9) is dependent on Database
Programming of Operator Code. If 9 is programmed, that is the code that must be
used to call the system attendant.
The Operator access code (0 or 9) is mutually exclusive with the outside CO line
access code.