6-26 Call Handling Configuration
Related Programming
Refer to “System Speed Dialing”.
UNS Conference Time
CO lines that are left unattended in conference (Unsupervised Conference) will be
allowed to remain in this status for the duration of the Unsupervised Conference Time.
Users that are familiar with the conference operation can extend this time during
operation by dialing [0] + [✳], or [0] + [#] to disconnect.
Default
The DHS/DHS-E Unsupervised Conference Time is set for 1 minute, and is variable from 1/
2/3/4/10/15 minutes.
Operator Code
The DHS/DHS-E Operator Code may be changed from 0 to 9 to meet special application
needs.
Default
The DHS/DHS-E Operator Code is [0], and the programmable value can be toggled either
0 or 9.
UNS Conference
Station users may leave two CO line connected parties in conference unsupervised. That
is, the station user does not have to remain connected to the CO lines to maintain the
conference connection. This setting allows or disallows this function.
Default
The DHS/DHS-E Unsupervised Conference is allowed Y, and the programmable value can
be toggled either Y or N.
Auto Busy Redial
The Auto Busy Redial function will attempt to Redial a specified number of times. Three
data fields are programmed for ABR operation:
ABR Attempts
ABR INTERVAL
TONE DET. TIME
System Speed Dial bin 99 must be programmed with a telephone number that will be used
as the ECF destination number for this feature to operate.
Unsupervised Conference requires the Option Module for operation. Single Line Telephones
(SLT) cannot conference.
To Next Page
Loading...
