6-24 Call Handling Configuration
Default
The DHS/DHS-E START field is set for 300 msec, and the END field is set for 800 msec. The
programmable range for the START field is:
100/200/300/400/500/600/700/800/900/1000/1100/1200/1300/1400
The programmable range for the END field is:
400/500/600/700/800/900/1000/1100/1200/1300/1400/1500
Direct Inward System Access (DISA)
Description
Any CO line(s) may be programmed as DISA lines. Calls ringing into the system on CO
lines designated as DISA lines will be automatically answered by the system and allowed
to access system resources (stations and CO lines). A special DISA code must be entered
to allow access of CO lines for out going calling. Restrictions are imposed on DISA CO
lines according to the COS assigned the DISA CO line. There are six data fields associated
to DISA programming; ACCESS CODE, DISA LINE, DISA DAY COS, DISA NITE COS, SERVICE
and TALK TIME.
DISA ACCESS CODE
–
24 codes may be entered to check for out dialing privileges.
DISA LINE
–
Set to Y or N for any of the CO lines indicating its use as a DISA CO line.
DISA DAY/NITE COS
–
Assigned per CO line and assigns a restriction level to callers
using DISA for out going calls.
SERVICE
–
Allows the programmer to set the DISA operation to actuate during
specific system modes.
TALK TIME – Sets the preset time limit of any DISA call. This time limit may be
extended during operation if the user dials a [0]+ [✳], or [0] + [#] to terminate. Doing
so will allow the conversation to continue for a second period of time equal to the
TALK TIME setting.
.
Default
The DHS/DHS-E default settings of associated DISA data fields are:
ACCESS CODE = Empty
DISA LINES = N (none assigned)
DISA DAY COS = 0
DISA NITE COS = 0
SERVICE = Never
TALK TIME = 1
DHS requires the Option Module, for correct operation of this Feature.
To Next Page
Loading...
