Resource Configuration 6-29
Resource Configuration
If the system is in the programming mode, continue using the [back] and [next] Soft
Buttons to scroll to the desired programming field. If starting to program here, enter the
programming mode.
Refer to “Program Mode Entry”. Also, refer to Table 6-1: Database Programming Table for
the complete list of programmable features and their default values.
Ring Scheme
The system may be set to three different ringing schemes. In Scheme 0 and 2, ringing is
differentiated by cadence so that a user is aware of the type of call ringing at his station
by the tone cadence. In Scheme 1, ringing of both intercom calls and CO line calls is the
same. This option is provided when the application requires that ringing adhere to RS-
478 ring cadence specifications.
Default
The DHS/DHS-E defaults to Ring Scheme 1.
Letter Type
The displayed characters for the messaging features and the Name in Display feature can
be adjusted to accommodate special character requirements. When programming
display messages the [1] button on the dial pad is pressed to insert special characters.
One of six possible Letter Types may be selected for use when dial pad key [1] is pressed
multiple times. Use the chart at the left to determine which Lettering Type Scheme is
desired for this installation.
Table 6-2: System Ring Scheme
SCHEME 0 SCHEME 1
*
* Recommended for Voice Mail.
SCHEME 2
ICM Tone Ringing 1s ON, 3s OFF 1s ON, 3s OFF 300ms ON, 400ms OFF,
300ms ON, 4s OFF
CO Line Ringing 300ms ON, 400ms
OFF, 300ms ON, 4s
OFF
1s ON, 3s OFF 1s ON, 3s OFF
To Next Page
Loading...
