2-24 Preparation for DHS Installation
Six conductor modular jack assemblies for all station instruments (recommended).
Standard punch-down terminal block(s), 66M1-50 type, as required.
Industry-standard, 25-pair cable(s) with a 50-pin male amphenol/AMP type
connector for connection from each equipped 3 x 8 module to the MDF.
AC voltage surge/spike protector.
Standard telephone hand tools and mounting hardware for the KSU, MDF backboard,
punch-down terminal block(s), modular jack assemblies for CO lines, etc.
Some additional tools suggested to have on-hand when installing the DHS system
include:
1 box 4 pairCat3 orCat5 twisted pair
Drywall screws
Multi-meter (fluke)
25 pair Amp cables (male-female)
Electrical tape
Permanent marker (0.8 mm,
0.5 mm for certain
applications)
25 pair Cat3 cable
Extension cord (three-
prong with ground)
Phillips head screwdrivers:
#1 x 4
#2 x 4
#2 x 6
89B-Brackets
Fiber rod for fishing walls
Phone jacks
B splice connectors or Scothlok
TM
splicing connectors
Fish tape
Punch Down Tool (110 and
66 Block Blades)
Bridge clips
Harmonica adapter
RJ11 plugs
Butt set (T.S. if possible)
In-line adapter
RJ45 plugs
Chain for fishing walls
Ladder
Standard screwdrivers:
1/8 x 4 in.
1/4 x 4 in.
3/16 x 6 in.
5/32 x 4 in.
Computer with RS232
Level
Static/Ground Strap
Cordless drill
Linesmen scissors
Toner
Diagonal wire cutters
Long nose pliers
Wand (Induction Amp)
Digit grabber
M1-66 split blocks
Wire spools
Drill
Modular crimping tool
(RJ-11 and RJ-45)
Yellow 77 (lubricant for wire)
To Next Page
Loading...
